Posts Made By: mustangracer84

I'm just throwing this out to see if anyone has something to sell/trade... and depending on how nice or what it is, I've got a lot I'd throw their way.

basically I'm looking for a pre-95 truck, or bronco/explorer/blazer/jeep. I don't care if it has a motor or not, or if the engine is ...

I guess I musta missed some post somewhere... what happened to "the red dragon"?

I am selling a 750cfm Holley double pumper with a Holley electric choke add on kit installed. Chrome fuel log included. This has only been ran on an engine dyno for two pulls....that's it. This is NOT a rebuilt carb. Was literally bought new, removed from box and ran two engine pulls then removed ...

Lol, same here... I understand completely. I lowered the price to help out as much as possible

Still available...lots of interest but still no takers. If you are awaiting the price to go lower, it has about hit bottom. I have well over the asking price for them into them. Need to sell, drop me a line!

Iirc there is/was a shop I wanna say out by Tulsa that is/was doing fox 4.6 conversions as a turnkey deal? Maybe some one can chime in if they know anything about it?

how much power? 12v? is this a 04 seat in a 92?

did you pull the bulkhead connector and check it for any pulled/pushed out pins? Sometimes a forgotten connection on the motor can pull out a wire from the harness when the engine is pulled/swapped. I'd consider two things... 1) put the oem tune back to stock and see if that code pops back up. 2) ...

Both. What carb are you running?

Are any of the o2's new? I would replace one and disconnect the harness to the other and see what it does. Sounds like a o2 heater is shorted to the sensor lead within a sensor.

I have a nos knob for a bullitt mustang, and a aluminum hurst pistol grip knob. Call/text me at (580)478-8430 if you are interested

I have a nos knob for a bullitt mustang, and a aluminum hurst pistol grip knob. Call/text me at (580)478-8430 if you are interested

Are you wanting a specific set? Just rims? Or rims and good tires? Shoot me a text/call and I'll give you a run down of what I have available... (580)478-8430 --David

Personally I would consider selling the cobra and keepin the truck. Trucks are soo nice to have for hauling and going places you wouldn't want to take a mustang

Pics sent, thanks!

Ok, maybe I am expecting too much with current economy? New price-- $250 firm, as is, where is, no headrests, no seatbelt hooks... Also, I looked at them the other night, and noticed the d/s hinge trim panel is missing. Trades are considered, but really could use the money.
...

Dunsworth machine shop in Enid, has done quite a bit of that stuff in the past.

hi everybody, my name is David, and I have a 2.3L turbo...

BTW, what kinda "shell" are you looking for?

all requests answered and pictures sent... still available.

Bump, still available, pictures available to be texted or emailed

Price is obo!