Posts Made By: matt is (eg6)

where do these plug in?

lol ill bring it by next time i head out that way. where do you take your scrap? ballpipe in shawnee suck ass and they always try to get stuff at crackhead prices..

yeah i might do that for the time being. on a side note i got the motor pulled out of the black car and bought all the gaskets just gotta swap the intake and pan and ill be ready to put the other motor in

sweet i know its a little much for a v6 but it will give it the stance i want

Im looking at getting a set of fr500's im thinking about getting the 17x9 and 17x10.5 will they fit without rubbing or poking on rear? Im stock height right now but im planning on lowering it soon im looking at eibach pro kit or h&r.. I dont have a problem rolling the fenders but just need to ...

if anyone knows how to take off the torque converter access plate please let me know im stuck on this and have been since 5 yesterday, in my haynes it says to pry it? but when i try it just springs back and doesnt really bend out far enough to get a socket on please let me know if anyone has had ...

405 973-4332

how the hell do you get the access plate off/out of the way??? Im prying on it and its just popping back into place

if anyone would be willing to help it would be great im almost done pulling the motor out of my girlfriends car but i still need to pull the engine out of the donor car i bought from botldpony yesterday and put that one in my girlfiends car lol

Im from shawnee wish i was closer to you so i could get another set of hands helping out.. but i took the 13mm bolts off the mount to engine part because i couldnt get a 1/2'' drive rachet or my impact in there.. but now i ran into another snag i have all the bolts out of the bell housing and the ...

anyone know of a good step by step or how to on pulling a 3.8 i have the motor almost out just need a few bolts on the bell housing off and the motor mounts.. Im trying to get the mounts loosened but cant really get on the bolt very good is the size 21mm? i tried 7/8 and 13/16 neither fit.. anyone ...

thanks Ill pm them

but that puts me in the same boat im in now. If i get them from a junkyard and they are cracked then im s.o.l...I know ebay has some that are rebuilt and i read somewhere on another forum there was a company that made ''NEW'' heads i think its out of florida but cant remember just figured someone ...

oh i forgot to specify its for a 97 mustang

just needing a good 3.8 figured someone has a good one laying around that they pulled to swap for v8.. you can text me at (405) 973-4332 thanks matt

Ok so my girlfriends car had the dreaded blown head gasket that all the 3.8s get. I got the drivers side head off and was working on the passenger side when I rounded the head off the bottom left bolt by the firewall. i tried a few different bold extraction sockets and nothing so i ended up cutting